This welded wire mesh with 4.0 mm wire and a rectangular 10 x 30 cm opening is no longer just a mesh — it's a full-fledged rebar cage in a roll. This thickness and asymmetric mesh are designed for directional loads: the tight side (10 cm) takes the main forces, while the wider side (30 cm) saves metal without sacrificing strength. All intersections are automatically welded — the joints are strong and uniform across the entire length. The 2 x 50 meter sheet size allows you to cover long spans with a minimum of overlaps. The white marking on the ends indicates that this is a heavy-duty mesh from a special rolling series.
The mesh is intended for structures where the load acts primarily in one direction. It is ideal for reinforcing long foundation strips, retaining walls, access ramps, road slabs, and runways. It can be used in warehouse floors with forklift traffic, in tunnels, in monolithic slabs with large spans, and in structures where saving rebar is important without losing load-bearing capacity. The mesh is also used in agriculture — for reinforcing silage pits, manure storage facilities, and concrete channels.
The main advantage is optimization for specific loads. The tight side of the mesh provides high flexural strength, while the wider side reduces metal consumption. Four millimeters is a serious margin that allows you not to fear overloads. The white tip is a quick reference point among other meshes. If you need to reinforce a long structure with a clear direction of primary forces — this mesh will get the job done faster and without excess metal.